Thank you for your interest. CT output specifications must be issued based upon frequency, input current, and output burden. There are an infinite number of combinations that designers will use, so therefore it is impossible to put together a similar graph as you see in an op amp spec. Op amps can be modeled easily over various loading conditions due to their feedback nature. CT's cannot. We provide pinpoint specs at the typical power frequency of 60 Hertz. We would need to know a burden to calculate the expected output in a 200Khz application.
Unfortunately, your application does not fit this product. A single sided input (DC pulsed) cannot be sensed with this product in the standard fashion of CT sensing design. This is a true AC only CT which needs the core to be reset on every cycle. You could possibly use it with a flyback circuit on the secondary, however you would possibly find some difficulty adding the usual commutating diode and filter on the primary given its 1 pass nature.
Typically, a hall effect type device is used in this application. I have attached a PDF of our CRH E Series offered. It is still in the marketing stages but available thru special order. The drawback with these is that they do require some sort of external power supply.
Please let us know if you have any other questions.